Why heating systems in Basildon homes clog up.
Basildon was designated a new town in 1949, and most of it was built in the decades that followed, joining up older communities such as Laindon, Pitsea, Vange and Langdon Hills. The result is a borough with a lot of post-war terraced and semi-detached housing, older properties in the original villages, and newer estates added since.
In many of these homes the boiler has been replaced once or twice, but the radiators and pipework behind it are far older. Each time a system is drained, refilled or extended, fresh oxygen gets into the water, and the steel inside the radiators slowly corrodes. That corrosion becomes black iron oxide sludge, which settles along the bottom of radiators and gathers in the boiler’s heat exchanger. Essex is also a hard-water area, so limescale can build up in the boiler too, particularly where a system has been topped up with fresh water many times over the years.
You tend to notice it gradually: a bedroom that never quite gets warm, radiators that are hot at the top and cold underneath, or a boiler that has started to bang and gurgle.
What a power flush in Basildon involves.
Our engineers connect a Kamco power flushing pump to your heating system and drive water and cleaning chemicals through each radiator in turn at high flow. A MagnaClean magnetic filter sits in the circuit throughout and captures the loosened sludge, so it leaves the system rather than settling somewhere else. Once the water runs clear, we refill the system with corrosion inhibitor to protect it from here on. Our guide to what power flushing is explains each stage in more detail.
A few practical points worth knowing:
- No radiators need to be taken off the wall or disconnected.
- Most homes take a day: around 6 to 12 hours in an average house, longer where there is microbore piping.
- You receive a BS7593 compliance certificate when the work is complete.
- The work carries a 3-year guarantee, or 5 years with a MagnaClean filter fitted, provided the boiler is serviced every year and the inhibitor is topped up.
Booking power flushing in Basildon.
We’re based in South Woodham Ferrers, a short drive from Basildon, and we cover the whole borough, including Billericay and Wickford. Our engineers are fully trained, DBS checked and covered by public liability insurance up to £5,000,000, and we have more than a decade of power flushing experience in family homes, rented properties and commercial premises.
A clean system heats up faster and works the boiler less hard, and customers can save up to 25% on their heating bills. For a rough idea of cost, our online estimate takes about a minute, and booking online qualifies you for a free £25 pump service. Or call us on 0800 3277 448 for a free, no-obligation quote.
